Angled Drill Chuck
"A
lovely sized item which easily deals with those awkward and hard to
reach areas. For fairly lightweight jobs, this will last for many
trouble-free years. The only criticism I have is that there is no handle
to allow one to hold it in place effectively. The cheaper 'angle-drill'
has one, but it is not at 90 degrees and is much smaller. A shame on
both accounts.""Very good for when drilling inbetween joists and where you cant fit the whole drill in a small place. its very heavy duty"Great
for drilling holes through joists and also for driving screws in
awkward positions. A little expensive but a lot cheaper than buying a
dedicated angle drill. I haven't used it enough yet to determine how
robust it really is but it feels pretty solid.Fits into a 10mm chuck in the same way as a drill bit to make access to
awkward places easier. Use with drill bits and wire brushes.
this drill to drill holes into bottom of stud work underfloor boards to route cable through done the job easily"
No comments:
Post a Comment